Frame - 2007 Solid Euro Killing Machine 20.5"
Fork - Macniel ID with 990 mounts
Bars - Primo Tall Boys
Stem - Redneck XLT
Barends - Alone
Grips - Alone
Headset - Solid Needle Bearing
Seat - Colony
Seatpost - Odyssey Intac
Seat Clamp - S&M
Rear Wheel - Prolite Cassette with Ti Axle on Alex Supra Feather
Front Wheel - Fit Team
Cranks - Profile Race (same one's I have about 10 years!) but now with Ti Axle
Pedals - Odyssey PC Twisted
Sprocket - 28t WTP
Chain - KHE Half link
Brakes - Front Odyssey Evolver, Rear Tektro FX20. Texh 77 Levers
Cables - Front Odyssey Slic, Rear Dragonfly Upper, SST Lower, Proper Cable Hanger
Gyro - Yes, cobbled together with Odyssey/SST bits and a cable tie
Pegs - Front Coalition Alu, Rear Fly Ramp
Tyres - Primo V Monsters
Mods - 14 to 10 front axle converters, skimmed down to run inside fork. Cut seat post.

Finished putting this together today, not rode in nearly 4 years so pretty much having to relearn everything from scratch!

Looks pretty nice dude. Not too keen on the seat but each to their own and all that

Iv not seen a front brake on a custom for time now.. Props for that

Cheers dude, its all second hand bits (apart from the frame), the seat/post combo was mega cheap. Would like to upgrade to a pivotal, and upgrade the front wheel soon.
I have always rode with a front brake, finding light forks with 990 mounts wasn't easy!

Brakes, nice!

nice work Daniel-san - Kim sent me a pic of it and it looks nice

we will have to ride sometime when I'm not trapped in work or being forced to destroy my liver by the Mrs

Like the purple, and the frame simple because it's called killing machine!